The Porsche 924 Owners Club

Idelola Short shift gear change
Page 2 of 2

Author:  Nige [ Tue Sep 10, 2019 10:48 pm ]
Post subject:  Re: Idelola Short shift gear change

Linda wrote:
Carrera RSR wrote:
The shaft length needed after grinding down its width is 50mm and you need 100mm to support the knob, otherwise the tip goes flaccid in your hand. If you grind down further the knob will be 50mm Lower than stock which is not optimal for hand from steering wheel to shifter. Thankfully there was a threaded hole on the top of the shaft so I put a circa 60mm bolt into it and used a lock nut to hold it securely. Now the knob stays super stiff in your hand.

Must. Not. Comment. :angelic:

Oh go on, you know you want to

Page 2 of 2 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group